Performing the Power-On Self Test (POST) - UART Channel Loopback Test.PASS Testing the System SDRAM.PASS Boot1 Checksum Test.PASS Boot2 Checksum Test.PASS Flash Image Validation Test.PASS BOOT Software Version 1.0.0.03 Built 08-Jun-2004 09:48:10 CPU - FireFox 88E6218 ARM946E-S processor 64 MByte SDRAM. I-Cache 8 KB. D-Cache 8 KB. Cache Enabled.
Downloading code using XMODEM. I got 'Begin the Xmodem or Xmodem-1K transfer now. 1.0.1 boot code we just loaded on the switch. It should show a message that it is going to download a new firmware using the XMODEM.
Autoboot in 2 seconds - press RETURN or Esc. To abort and enter prom. Preparing to decompress. Decompressing SW from flash HOSTGrscodefileload: could not load file Perform WARM BOOT. When I attempt to do download the new software with XModem the firmware (fw) completes successfully (ls20xxSalsa-12222.ros) but the boot image fw fails (runtopboot-101.rfb) and I receive this message: Startup Menu 1 Download Software 2 Erase Flash File 3 Password Recovery Procedure 4 Set Terminal Baud-Rate 5 Back Enter your choice or press 'ESC' to exit: Downloading code using XMODEM. Download complete - Wrong file format. Writing aborted.
Is there a different version of the firmware perhaps an older version available for download somewhere? Or is there something I am doing wrong? Any help would be greatly appreciated.
We have 2 - srw2024's and 2- srw2016's. Issue only on the one with the fw upgrade.